NeuLog RF-201 Guia Del Usuario página 19

Setting the RF ID number:
For your RF modules to properly work they must be set
to the same ID channel (paired) so they can "speak" with
one another directly. This is done very easily using the
NeuLog application. Keep in mind, if you have multiple
pairs of RF modules in the same area they must be set to
different RF ID values (1 through 9) to prevent
interference.
1. Connect the USB module into your computer using
the included USB to micro-USB cable.
2. Connect both of the RF modules into the USB
module.
3. Open the NeuLog application.
4. Click on the "NeuLog Tools" button located at the top
of the screen.
5. Click on "Set ID"
6. Select an ID number (1 through 9) and make note of
your selection.
7. Note: To pair your RF modules, set the ID of each RF
to the same value (1 through 9).
8. Click on "Set RF ID".
9. Both of your RF communication modules are now set
to your chosen value (paired).
10. Note: This setup is not required prior to every use as
long as you keep modules with similar ID's paired for
experimentation.
V2018.03
19
Home
English