LG DL X860 E Serie Manual Del Propietário página 20

en-us_main.book.book Page 20 Thursday, January 4, 2024 1:46 PM
20 INSTALLATION
Interlock buttons
d
Inner lock rods
h
Upper hinge assembly
l
ON THE CABINET :
1
Reinstall the door.
• The door is now ready to remount on the
opposite side of the dryer.
• While supporting the door, install the two
small hinge screws removed from the
hinge. Test the swing of the door to make
sure the hinges and latch are properly
aligned and that the door opens, closes and
latches properly in both directions.
• If the door doesn't operate smoothly,
remove the door and then the door cover to
check that the lock rods and interlock
buttons are properly mounted and aligned.
• The interlock buttons should be oriented
correctly and operating smoothly. The
interlock rods should be in the proper
position and should not overlap at the
contact point. (See steps 12-14.)
• If the door is damaged, or if the door does
notwork after reassembly, contact the call
centerat 1-800-243-0000.
Lower hinge filler
e
Lower hinge bracket
i
Upper hinge pivot
m
Installing the Vent Kit
• Use long-sleeved gloves and safety glasses.
• Use a heavy metal vent.
• Do not use plastic or thin foil ducts.
• Clean old ducts before installing the appliance.
The appliance is configured to vent to the rear. It
can also vent to the bottom or side.
NOTE
• An adapter kit, part number 383EEL9001B, may
• Right-side venting is not available on gas
Side Venting
1
Side lock rod
f
Hole plug Lower hinge assembly
j k
Upper hinge filler
n
WARNING
be purchased from your LG retailer. This kit
contains duct components necessary to change
the appliance vent location.
models.
Remove the rear exhaust duct retaining screw
and pull out the exhaust duct
a
Top lock rod
g
.
b