Descargar Imprimir esta página

Panasonic ER-GP21K Instrucciones De Funcionamiento página 9

Cortadora de cabello profesional recargable

Publicidad

Idiomas disponibles

Idiomas disponibles

Charging the clipper
• Make sure that the clipper is turned off.
1
1
Place the clipper on the AC
adaptor.
2
2
Insert the power plug into a
household outlet.
• Charging is completed after approx.
15 hours.
• Check the charge indicator lamp
(
) glows.
3
3
Disconnect the power plug after charging is
completed.
(for safety and to reduce energy usage)
• The charge indicator lamp (
charging is complete. There is no indication to show that
"charging is complete".
Notes
• If there is crackling noise on radios or other devices while
charging, charge the clipper using a different household outlet.
• When the appliance is not used for 6 months or more, the battery
will weaken (leak battery fluid, etc.). Fully charge the battery
once every 6 months.
• When charging the clipper for the first time or when it has not
been in use for more than 6 months, the lamp on the main body
may not glow for a few minutes, or the operating time may
shorten. Please charge it for more than 23 hours in such cases.
• Recommended ambient temperature for charging is 0 °C – 35 °C
(32 °F – 95 °F). Battery performance may decrease outside of
the recommended temperature.
• 1 full charge will provide approximately 60 minutes of continuous
operation.
ER-GP21_US.indb
9
2
2
1
1
) continues to glow after
• You can charge the battery before it is completely discharged.
However, it is recommended to charge when the battery is
completely discharged. The battery life depends strongly on
factors such as how it is used and stored.
Using the clipper
• Make sure that the clipper is turned off.
• The appliance may not operate in an ambient temperature
approximately 0 °C (32 °F) or lower.
1
1
Select the trimming heights indicated on the
insides and sides of the attachments.
2
2
Slide the power switch on the main body to the
" " position to turn on the clipper.
Removing and mounting the comb attachments
Mounting the attachment
(Example: in the case of 3 mm
(1/8˝))
Slide the attachment until it
clicks.
Removing the attachment
Remove the attachment by pressing
with your thumb.
3mm
click
9
2016/03/17
16:09:07

Publicidad

loading

Este manual también es adecuado para:

Er-gp21