Kingfisher CLCG60LKSS Manual Del Usuario página 73

3. Turn on the hob and make sure the connectivity indicator is lit.
NOTE: Touch the connectivity key on the hob if it is not lit.
4. Press the two front cooking zone keys
to confirm connection.
5. The control panel of the hood will show A for five seconds to indicate connectivity has been made with
the hob.
6. Press the two front cooking zone keys together on the hob before A disappears to store the connectivity
settings.
IMPORTANT: The extraction rate of the hood will vary based upon the total
power output selected on the hob, as shown in the table below.
Each hob cooking zone has a maximum rated output of 10 comprising 1-9 and
Boost (10).
Speed Level of the Hood
Speed 1
Speed 3
Speed 5
Speed P - Boost
NOTE:
• Speed 2 and Speed 4 on the hood are not available when using this function.
• If the hood controls are manually overridden when the hob and hood are linked, the hood will operate
for five minutes on this manual setting before returning to control by the hob. To reconnect the hood and
hob immediately, press the Timer
05 Stopping the connectivity function
1. Touch the connectivity key on the hob, the indicator light will go out and the link will be dropped.
To reconnect again, press the connectivity key on the hob again.
2. If the hob is switched off, the hood will continue to operate independently in Timer mode and the current
speed will flash. The current speed level of the hood will continue for 5 minutes and step down for
2 minutes at each level until finally switching off.
5059340446103_MNL_IN_V04.indb 72 5059340446103_MNL_IN_V04.indb 72
together on the hob and the connection indicator will flash
Combined Power Output of the Hob
This speed will be selected when there are no more than two cooking zones
in use, and the combined output is 8 or less. For example, zone 1 is on 2,
and zone 2 is on 5.
This speed will be selected when there are no more than three cooking
zones in use, and the combined output is between 9 and 24. For example,
zone 1 is on 7, zone 2 is on 6 and zone 3 is on Boost (10).
This speed will be selected when all four cooking zones are in use, or the
combined output is between 25 and 35. For example, zone 1 is on 7, zone
2 is on 7, zone 3 is on 6 and zone 4 is on Boost (10).
This speed will be selected when more than 3 cooking zones are in use, and
combined output is 36 or higher.
and Light together.
72
8/6/2022 3:47 PM 8/6/2022 3:47 PM