Publicidad
Check: PARKING MODE/MONITOR and MOVEMENT DETECTION - function
designed to operate while the vehicle is parked. Deactivate the function, before
setting off, as it may cause the camera to switch on and off and make random
fragments of route recordings.
If the functions are disabled, check if the fault occurs without the memory
card inserted.
5. The camera records fragments of the route / randomly ongoing recordings
Check: MOVEMENT DETECTION - a function designed to operate while the
vehicle is parked.
You need to deactivate the function, before setting off, as it can cause the
camera to switch on and off and make random fragments of route recordings.
If the function is deactivated, check if the fault occurs without a memory card
inserted.
6. The device shows the message „card full" or does not read the card
Check the „G-sensor" and „parking mode" functions and set them to minimum.
The card must be formatted in the computer in the FAT32 or exfat file system
(depending on the card) and then in the recorder.
Also check: Is the selected card capacity and specification (micro SD, class 10 -
U1, V10 additionally recommended) suitable for your device (we recommend
using cards from reputable manufacturers, we recommend: Kingston, Samsung,
Sandisk).
If you encounter an error at any stage, replace the card with a new one from an
official distribution.
7. The device records noise, distorted, unclear sound
The device has a highly sensitive microphone that records any ambient noises.
The recorded sounds may overlap. Windscreen air vents can also distort the
sound.
8. The device does not respond
Press the Reset button briefly or return the device to factory settings.
9. Transverse stripes are present in the footage
Incorrect setting of the frame rate value. Set the frequency value to „50Hz" or
„60Hz" depending on local settings.
10. Handle detaches from windshield/does not stick
Degrease the surfaces well before mounting the holder on the glass. Remember
to avoid high temperatures, which can cause deformation of the holder, and
damage to the recorder itself.
NOTES:
- G-SENSOR - a function thanks to which recordings with recorded overloads (e.g.
uneven road surface, braking, driving off a kerb or over a speed bump, etc.) are
protected from being overwritten. If the user uses this function, the memory card
16
must be formatted periodically on the computer and then on the camera. Ulti-
mately, each file on the data carrier will be protected from being overwritten and
the device will not be able to record a further route - it will not record in a loop.
We suggest setting the sensor according to your driving style and road conditions.
This option can also be completely disabled, in which case each oldest file will be
overwritten and the card will not need to be formatted periodically.
- PARKING MODE/MONITOR - a function designed to operate while the vehicle is
parked, uses battery power* if the recorder is fully charged - (*if it has a built-in
battery) . In this case, the camera starts recording a video of a few seconds after
detecting a shock - until the battery is discharged. When using this function, bear in
mind the battery of the device, which needs to be recharged after the function ac-
tivates (starts). You should deactivate the function, before setting off on a journey,
as it may cause the camera to switch on and off and make random fragments of
recordings from the route.
*The constant power supply in the vehicle may cause this function to behave
differently, e.g. leaving the camera on, which may drain the car battery.
- MOVEMENT DETECTION - a function designed to operate while the vehicle is par-
ked - requires constant power and the camera must remain switched on. The DVR
will start recording automatically when motion is detected, and will stop recording
a few seconds after there is no movement in front of the camera lens. Please note
that this function may drain the car battery.
You need to deactivate the function, before setting off, as it can cause the camera to
switch on and off and make random fragments of route footage.
Due to continuous product improvement, the manufacturer reserves the right
to make changes to the device and its kit without prior notice. Some functions
described in this manual may differ slightly in reality.
09. NOTE
1. Due to continuous product improvement, the manufacturer reserves the
right to make changes to the device and its kit without prior notice. Some
functions described in this manual may differ slightly from reality.
2. Use only the original charger with a charging current of 5V/1.5A. (Do not
plug directly into a 220/230V socket). Failure to follow the recommendations
may damage the camera or lead to dangerous situations.
3. The ‚Park Mode' function only works on direct battery power or battery
power. It relies on the fact that when an impact is detected (depending on
the sensitivity of the sensor set), the camera starts up and records for a
period of time according to the recording loop settings or until the battery is
discharged and then switches off, this allows the unit to remain in standby
mode for as long as possible. Parking mode recordings may be of lower qu-
ality due to the lower frame rate characteristic of this mode. The manufactu-
rer accepts no responsibility for failure to record any damage caused when
17
Publicidad
