Safety Instructions - Atmor InLine 900 Serie Guía De Instalación Y Funcionamiento

Safety Instructions

OVERVIEW
This manual must be read carefully before attempting to install the water heater. If you do not follow the safety rules or the
instructions outlined in this manual, the unit may not operate properly and it could cause property damage, serious bodily injury
or death.
Atmor will not be liable for any damages because of failure to comply with the installation and operating instructions
outlined in this manual or because of improper use. Improper use includes the use of this appliance to heat any liquid other than
Failure to comply with the installation and operating instructions or improper use voids the warranty. Never
water.
remove the unit's cover unless the electricity is turned off.
01
The water heater must
be installed by a licensed
electrician and in compliance with
all local electrical and building
regulations.
04
The heater must be installed
according to the installation
instructions (see figures).
07
The plumbing installation
requires metal or reinforced
pipes that can withstand a
minimum pressure of 8 bar.
(Other types of pipes will cause
damage.)
1
02
Caution: The appliance must be
grounded.
05
The plumbing installation
must be completed before the
electrical installation.
08
Do not install the heater where
it may be subjected to direct
sunlight, rain and/ or a constant
spray of water.
03
A dedicated circuit breaker
must be installed on the power
distribution panel.
06
The heater operates at a
minimum water flow rate of
0.5 gallon/minute.
09
Always contact your
local authorized licensed
proffessional for service.