Publicidad
Idiomas disponibles
Idiomas disponibles
ASSEMBLY
ADDING BAR AND CHAIN LUBRICANT
Use a bar and chain lubricant with this product. It is designed for chains and chain oilers, and is
formulated to perform over a wide temperature range with no dilution required.
•
Remove oil cap. Open the removable cover (1) and then rotate the cover counterclockwise
to remove it (2).
•
Carefully pour the bar and chain oil into the tank (3).
•
Wipe off excess oil and replace cap.
•
Check and fill the oil tank when quick view oil indicator is below the MIN. line.
•
Repeat as needed.
Step 1
Step 1
Step 3
Step 3
NOTE: Chainsaw comes from the factory with no bar and chain oil added. The level should also
be checked after every 20 minutes of use and refilled as needed.
NOTE: Do not use dirty, used, or otherwise contaminated oils. Damage may occur to the bar or
chain.
NOTE: It is normal for oil to seep from the saw when not in use. To prevent seepage, empty the
oil tank after each use, then run for one minute. When storing the unit for a long period of time
(three months or longer) be sure the chain is lightly lubricated; this will prevent rust on the chain
and bar sprocket.
Step 2
Step 2
13
Publicidad
