Hilti SIW 6 AT-A22 Manual De Instrucciones Original página 15

1. Set the forward/reverse switch to the middle position or remove the
battery from the power tool.
2. Pull the accessory tool off the square drive.
5.1.7 Setting the torque
▶ Select one of the following alternatives:
5.1.7.1 Operation without the intelligent torque module
▶ Push the torque selector button repeatedly until the desired torque
setting is displayed in the torque display.
5.1.7.2 Operation with the intelligent torque module
"AT" lights in the torque display (intelligent torque mode).
▶ On the intelligent torque module, set the correct type of anchor or
threaded stud to be fastened or the screw to be used (→ Operating
instructions for the intelligent torque module).
▶ When "AT" lights in the torque display, the torque selector switch is
inoperative. Speed and torque are regulated by the torque module.
5.2 Types of work
CAUTION
Risk of damage by incorrect handling!
▶ Do not operate the switches for direction of rotation and/or function
selection during operation.
Observe the safety instructions and warnings in this documentation and on
the product.
5.2.1 Setting forward or reverse rotation
▶ Set the forward/reverse switch to the desired direction of rotation.
▶ An interlock prevents switching while the motor is running.
▶ The control switch is locked when the forward/reverse switch is in
the middle position (switch-on interlock).
5.2.2 Switching on
▶ Press the control switch.
When operated without the intelligent torque module: Speed of
rotation is regulated by the travel of the control switch.
When operated with the intelligent torque module: The control
switch works only as an on/off switch and the speed of rotation is
controlled via the intelligent torque module.
*2124662*
2124662
4
English 11