Publicidad
The 2-Way WL Panda for LightSYS Air/LightSYS Plus keypad is used to remotely
program and operate the LightSYS Air/LightSYS Plus control panel. Being bi-directional,
the 2-Way keypad receives a reply status indication from the panel for each command sent
to the panel. You can operate the keypad either using a code or a proximity tag.
Main Features
•
Bi-directional Wireless Communication
•
Full Wireless Installer Programming
•
Up to 2 WL Panda LightSYS Plus Keypads per WL Video Expander /
Up to 8 WL Panda LightSYS Air Keypads
•
S.O.S / Two-way communication emergency key
•
Proximity tag operation
•
Double tamper protection (Box & Wall)
•
Battery economy mode
Communication Setup
Note: For LightSYS Plus communication setup, use the RP432EWV WL receiver.
The WL Panda for LightSYS Air/LightSYS Plus keypad must identify itself to the system
receiver. This can be done by typing the 11-digit serial number of the keypad into the system
or using RF mode.
To set up the keypad using the serial number refer to the security system installation
manual.
Setup using RF communication:
1.
Set the receiver to Learn Mode.
2.
Send a Write message by pressing both keys
least 2 seconds. In a voice supported system, the keypad will sound a
confirmation beep and the system will beep to acknowledge.
3.
If required to change the keypad's default settings, configure the keypad's
parameters according to the system installation manual.
Note: Adding the keypad to the system can be done remotely using the
configuration software by entering the serial number of the keypad.
Note: The firmware update is done by FOTA - Firmware Over The Air Technology.
In case a newer firmware is available for the keypad (due to keypad enrollment or
remote panel upgrade) the keypad will be upgraded immediately after the panel's
remote upgrade or during exit from a programming mode.
10/2023
Page 3
simultaneously for at
5IN3045 C
Publicidad
