Delta 23-206 Manual De Instrucciones página 11

TOOL STORAGE
Your DELTA 23-206 (6 inch) or 23-207 (8 inch) Grinder has
®
convenient on-board tool storage for the Wheel Dressing Tool
provided. The tool holder is located on the rear of the grinder
PC7
base.
See Figure 3.
CONFIRM TIGHTNESS OF ARBOR
NUTS
Prior to using your grinder for the first time, it is recommended
that you check the tightness of the arbor nuts. To check the
tightness on the arbor nuts, do the following:
1.
Remove the two screws
the wheel guard to the tool frame. You will also need to
remove the long carriage bolt that secures the Tool Rest
Support by removing the lower large locking knob. See
Figure 4.
2.
Remove guard.
3.
Using 24mm wrench, tighten the arbor nut
using the other hand to keep the wheel from moving.
Tighten the arbor nut snug. See Figure 5.
NOTE: The arbor nut on the right side of the machine tightens by
rotating it clockwise, the arbor nut on the left side of the machine
tightens by rotating it counterclockwise.
4.
Re-attach and secure the outer face of the wheel guard
to the tool frame using the screws
Step 1. See Figure 4.
5.
Repeat process for other side.
NOTE: As you use your grinder, the force and direction of the
wheel will cause the arbor nut to tighten automatically. However,
it is recommended that your periodically check the tightness of
the nuts as part of your regular tool maintenance.
ASSEMBLY
securing the outer face of
A
while
B
by reversing
A
PC7
A
B
11
Figure 3
Figure 4
Figure 5