Publicidad
Idiomas disponibles
Idiomas disponibles
the range hood canopy. Plug the 4 wire quick connect cord from the blower
SECTION 3
Installation into 10" High Canopy
1. Remove the rear bottom plate of the hood canopy. It is secured in place
mounting flange overthetwo studs of the hood. Slide the blower into place
and tighten the hex nuts on the mounting stud while lining up the 8 holes
in the blower mounting flange to the 8 screw studs of the hood (Figure 1).
Using 8 of the included 8-32 screws and washers, mount the blower in
into the one end of the wiring harness then connect the other end of the
wiring harness to the receptacle in the range hood canopy. These cords
and washers removed in Step 7 (Figure 4).
REPLACEMENT PARTS DIAGRAM
©
Publicidad
