Publicidad
Idiomas disponibles
Idiomas disponibles
Problem
Water flows on the floor.
Temperature cannot be set.
The temperature in the appliance is
too low/too high.
Power indicator light flashes.
If the advice does not lead to the desired
result, call the nearest Authorized
Service Centre.
8.2 Closing the door
1. Clean the door gaskets.
14
ENGLISH
Possible cause
Temperature set in the appliance is
too low and the ambient tempera‐
ture is too high.
The melting water outlet is not con‐
nected to the evaporative tray below
the appliance.
The Frostmatic function is switched
on.
The temperature is not set correctly. Set a higher/lower temperature.
The door is not closed correctly.
The food products' temperature is
too high.
Many food products are stored at
the same time.
The thickness of the frost is greater
than 4-5 mm.
The door has been opened often.
The Frostmatic function is switched
on.
There is no cold air circulation in the
appliance.
An error has occurred in measuring
the temperature.
2. If necessary, adjust the door. Refer to
3. If necessary, replace the defective door
Solution
Set a higher temperature. Refer to
"Control panel" chapter.
Attach the melting water outlet to
the evaporative tray.
Switch off Frostmatic function man‐
ually, or wait until the function deac‐
tivates automatically to set the tem‐
perature. Refer to "Frostmatic func‐
tion" section.
Refer to "Closing the door" section.
Let the food products temperature
decrease to room temperature be‐
fore storage.
Store less food products at the
same time.
Defrost the appliance.
Open the door only if necessary.
Refer to "Frostmatic function" sec‐
tion.
Make sure that there is cold air cir‐
culation in the appliance. Refer to
"Hints and tips" chapter.
Contact a qualified electrician or the
nearest Authorized Service Centre.
installation instructions.
gaskets. Contact the Authorised Service
Centre.
Publicidad
