Publicidad
an Elcometer company
13. Maintenance
In order to carry out maintenance, repairs or cleaning, first disconnect the unit from the network.
Do not apply excessive force or inadequate tools for maintaining and cleaning the unit. Some
repairs must be done with special tools on some occasions. In these cases, you must contact the
Customer Service of SAGOLA. Any handling of this product by non-authorised personnel
would render the warranty null and void.
The unit must be overhauled on a periodic basis to check the status of its components and
replace these when they are not in perfect condition.
In order to obtain the best possible results, always use
ORIGINAL SAGOLA SPARES. ensure total interchangeability,
safety and operation.
Filter Replacement
In order to replace these, proceed as follows:
Close the air valve leading to the unit. Discharge the pressurised air. With the unit totally
depressurised and follow the steps below:
Sintered Bronze Filter
As a general rule, SAGOLA recommends
replacement every six months or cleaning it
with an adequate thinner or its.
01
Unscrew lower section
05
Replace Spare filter
EN
30
02
Unscrew nut and washer
06
Grease the thread of the
vessel
03
Extract filter
07
Place lower section
04
Clean the shaft
08
Place calendar
www.sagola.com
Publicidad
