Publicidad
Idiomas disponibles
Idiomas disponibles
ASSEMBLY & INSTALLATION INSTRUCTION
TOOLS NEEDED: (not provided)
1. Pencil
2. Hammer
3. Level
4. Screwdriver
5. Power drill and drill bits
A mounting bracket is provided with the heater which has been specifically designed to allow this product to be
fitted to a ceiling or wall. Ensure that there are no water pipes or electrical wires before drilling.
ATTENTION: The appliance must be installed on the solid surfaces like concrete, wood or metal etc.
Important: Ensure the supply cable is well mounted and that it does not come into contact with reflector of the
heater or that does not trail into heated area, the supply cable can be fixed to the metal mounting bracket
behind heater with plastic zip ties.
1.
This heater should be installed by a competent person, i.e. a qualified electrician.
2.
Always disconnect the heater from the electricity supply and allow it to cool before installation.
3.
Keep the supply cord away from the body of the heater which will get hot during use.
4.
If the heater is to be used outside, a weatherproof outlet is recommended.
5.
Fasten the heater securely on the baseplate using the screws supplied.
6.
For both horizontal and vertical mounting on the wall, there must be a min. distance of 0.4m/15.8"
between the appliance and the ceiling.
7.
The distance from your appliance from the corners should be min. 0.4m/15.8" for vertical use and min.
0.5m/19.7" for horizontal use.
8.
When installed to the ceiling, there must be a distance of 0.5m/19.7" between corners and the appliance.
9.
We recommend keeping a minimum clearance from the heating unit at 3 feet / 0.9 meters.
10.
The distance from the front side of the heater to materials such as wood, carton, cloth etc., must be min
1m/39.4".
11.
When mounting horizontally or to a ceiling, do not position the heater at an angle more than 90°and
less than 45°.
12.
The supply cable must be at the lower end of the heater if the heater is installed at an angle or vertically.
13.
Do not install the heater on an inflammable surface.
14.
Observe the minimum safe distance between the heater body and the inflammable surfaces when
mounted.
15.
The heater should always have a minimum clearance of 0.5m/19.7" from the adjacent wall.
16.
The heater must be installed on the mounting brackets provided.
17.
Fasten the brackets securely to the mounting surface and the backside of the heater using the nuts and
screws supplied.
18.
The brackets can be used to adjust the direction of the heater, adjust the heater angle by loosening the
two bolts on the wall mounting bracket, tighten the bolts again when the desired angle is reached.
12
Publicidad
