Panasonic EY78A1LJ2G Manual De Instrucciones página 14

• If both the battery low warning lamp
and LED light flash, reduce the force
with which you are pushing on the
driver or, if using a drill driver, adjust
the speed switch to a lower setting.
(EY78A1)
Installing the Shoulder Strap
CAUTION:
• Install the shoulder strap firmly
to the main unit of the tool and
check the length of the strap
before use.
• Check the condition of the strap
and do not use if it is cut or torn
etc.
There is a risk of injury or dam-
age if used while improperly in-
stalled.
• Please wear the shoulder strap
securely on the shoulder.
There is a risk of injury or dam-
age if it is accidentally dropped.
1. Pass the strap through the strap
holders. ( )
2. Pass the strap through the buckles
and adjust the length. ( )
Shoulder pad
• The shoulder strap can be adjusted
according to the individual.
• Adjust the shoulder pad to the
shoulder.
• Pull the shoulder strap to make sure
it is firmly attached to the main unit of
the tool.
Dust Collection Cup (EY9X005E)
(Available as an optional accessory)
* Drill bits of which diameter is 20 mm
above cannot be inserted through
dust collection cup.
* Do not use the tool for cutting other
than concrete, mortar and other ceram-
ic materials. If used for cutting metal
materials, the dust collection cup may
be damaged by the metal chip heat.
* Do not use this tool with any drill bit
which is shorter than 130 mm in length.
1. Install a drill bit.
2. Pass the drill bit through A and fix
the cup at B by matching with the
shape of the cluch handle.
B
A
Operation
Keep the dust collection cup in close
contact with the wall surface during
operation.
Removal
Hold the base of the dust collection
cup for removal.
Please remove after thoroughly get-
ting rid of the dust in the dust collec-
tion cup.
- 14 -
- 14 -
Base