Midea MSF42B9AWT Manual De Instrucciones página 6

INSTALLATION INSTRUCTIONS
Installation Steps
1. Remove the air inlet
grille.
2. Remove the pre-filter
by pressing the raised
part on both sides and
pull outwards.
3. Remove the protective
film of the filter.
4. Install the HEPA filter.
5. Install the pre-filter by
aligning the slots in
position located at the
bottom, then secure
the upper U-shaped
clip.
6. Install the air inlet
grille by aligning the
upper two clips and
press tightly, then
press the two sides on
lower portion, slowly
and gently clip the air
inlet grille in place.
7. Plug-in power cord.
NOTICE
It is recommended to clean the filter once every two weeks and replace it
once every six months (the cleaning and replacement cycle can be adjusted
according to the use environment).
 Page 6 
1
Buckle
Clip
3
5
2
4
6
7
Buckling
position