Publicidad
Idiomas disponibles
Idiomas disponibles
NOTE: This r efrigerator isintended foruse ina location where t he
temperature
ranges from a minimum o f55°F (13°C) toa maximum
of110°F (43°C). The preferred room temperature
range f or
optimum p erformance,
which r educes
electricity
usage and
provides
superior
cooling,
is between
60°F (15°C) and 90°F (32°C).
It is recommended
that you do not install the refrigerator
near a
heat source, such as an oven or radiator.
1/2"(1.25 cm)
I
[
]
2" (5.08 cm)
/
\
Depending
on the width
of your door opening,
it may be necessary
to remove
the refrigerator
doors to move the refrigerator
into your
home.
IMPORTANT:
If the refrigerator
was previously
installed
and you are moving
it out of the home, before
you begin, turn the refrigerator
control
OFF, and unplug the refrigerator
or disconnect
power.
Remove food
and any adjustable
door or utility
bins from
doors.
Keep the refrigerator
doors
closed until you are ready
to lift
them free from the cabinet.
Provide additional
support
for the
refrigerator
door while the hinges are being removed.
Do not
depend
on the door gasket
magnets
to hold the door in place
while you are working.
All graphics
referenced
in the following
instructions
are
included
later in this section
after "Final Steps."
5/
"
3/,"
TOOLS NEEDED:
716
,
78 ,
and
1/4"
Hex-head
socket wrenches,
#2 Phillips screwdriver,
and a Flat-blade
screwdriver.
Remove Doors and Hinges
Electrical Shock Hazard
Disconnect power before removing
doors.
Failure to do so can result
in death or electrical
shock.
1.
Unplug
refrigerator
or disconnect
power.
2.
Remove the base grille. Grasp
the grille firmly
and pull it
toward
you.
3.
Starting
with the right-hand
side door, remove
the parts for the
top hinge as shown in Top Hinge graphic.
Lift the refrigerator
door from the bottom
hinge pin.
4.
Remove the hinge pin cover from the bottom
hinge pin and
keep it for later use. See Bottom
Hinge graphic.
5.
Remove top hinge cover from
left-hand
side refrigerator
door.
6.
Remove the parts for the top hinge as shown in Top Hinge
graphic.
Lift the left-hand
side door from the bottom
hinge pin.
NOTE:
On some models,
remove the hinge pin cover from the
bottom
hinge pin and keep it for later use. See Bottom Hinge
graphic.
Replace Doors and Hinges
1.
2.
3.
Assemble
the parts for the top hinges as shown in Top Hinge
graphic.
Do not tighten
the screws completely.
Replace
the parts for the bottom
hinge as shown in Bottom
Hinge graphic.
Tighten
screws. Replace the refrigerator
door.
NOTE:
Provide additional
support
for the refrigerator
door
while the hinges are being moved.
Do not depend
on the door
gasket
magnets
to hold the door in place while you are
working.
Align
the door so that the bottom
of the refrigerator
doors
align evenly with the top of the freezer
drawer.
Tighten
all
screws.
4.
Replace
the top
hinge
covers.
6
Publicidad
