Publicidad
Idiomas disponibles
Idiomas disponibles
USER INSTRUCTIONS
For the operating mode of the BUS connection and of the main unit, see the
instruction manual of the main unit.
1.u - POWER-UP AND NORMAL OPERATION
When switched on, or after a power failure, the appliance assumes
(it does not detect gas)
for
one
minute while the sensor warms up
A
fter one minute the appliance resumes "
Fig. 2 - "Non operating" status
Green LED - alight
!
Yellow LED - blinking
Red LED 1 - off
Red LED 2 - off
Red LED 3 - off
Buzzer - off
2.u - INDICATION OF VERY LOW AND LOW GAS
CONCENTRATION
If during normal operation the appliance detects a very low concentration of gas, the
red LED 3 will light up (fig. 4).
If the concentration increases, the red LED 2 will also light up (fig. 5).
Fig. 4 - Very low gas concentration
indicated
Green LED - alight
!
Yellow LED - off
Red LED 1 - off
Red LED 2 - off
Red LED 3 -
alight
Buzzer - off
non-operating status
(fig. 2).
normal operating status"
(fig. 3).
Fig. 3 - "Normal operation" status
Green LED - alight
!
Yellow LED - off
Red LED 1 - off
Red LED 2 - off
Red LED 3 - off
Buzzer - off
Fig. 5 - Low gas concentration
indicated
Green LED - alight
!
Yellow LED - off
Red LED 1 - off
Red LED 2 -
alight
Red LED 3 -
alight
Buzzer - off
3.u - INDICATION OF GAS WARNING AND GAS ALARM
If the gas concentration in the air exceeds the intervention threshold, the appliance
indicates this situation by activating the red LED 1 alarm and simultaneously emitting
an intermittent buzzer sound (fig. 6).
Fig. 6 - "Gas presence alarm" status
Green LED - alight
!
Yellow LED - off
Red LED 1 -
alight
Red LED 2 -
alight
Red LED 3 -
alight
1s 1s
Buzzer -
1 signal every second
Main unit in BUS connection only
In installations with multiple appliances which are BUS connected to a main unit, the
peripheral units, 15 seconds after the "gas presence alarm" state is activated, transmit
a signal to the main unit, which is placed in "gas presence alarm from BUS" state.
Warning: gas can be smelt in the environment before the
appliance signals alarm.
4.u - ALARM MEMORY AND CLEAR ALARM MEMORY
Fig. 7 - Alarm memory
Green LED - alight
!
Yellow LED - off
Red LED 1 -
blinking
Red LED 2 -
blinking
Red LED 3 -
blinking
Buzzer - off
The appliance memorizes when an alarm
has been triggered, and also at the return to
normal conditions in the environment, the
user can check whether or not there has
been an alarm in the environment (the 3 red
LEDS blinking) (fig.7).
To clear the alarm memory, press the
"
RESET
" button and the appliance will
return to "normal operation" status (fig. 3).
G
B
13
Publicidad
