Craftsman 211420 Instrucciones De Ensamblaje página 3

DO NOT ASSEMBLE the Bench Grinder Leg Set until
you have read and understand the entire instruction
Manual,
DO NOT ASSEMBLE the Bench Grinder Leg Set if
any parts are missing or damaged,
LEG SET ASSEMBLY
Figure 2-1
0
o
insert the 2 tabs on the end of the Upper Leg (6)
into the 2 shots in the Tray (1), See Figure 2ol,
Using a rubber mallet or a hammer with a wooden
Mock (Figure 2°2), tap the Upper ieg until the tabs
are fuliy engaged into the Tray, See Figure 2°3,
Figure 2-2
Figure 2-3
2, Repeat Step 1 on the remaining Upper Legs,
3, insert the 2 tabs on the end of the Lower Leg (7)
into the 2 slots in the end of the Upper Legs (refer
to Figure 2ol), Using a rubber mallet or a hammer
with a wooden block, tap the Lower leg until the
tabs are fully engaged into the Upper Leg,
4, Repeat Step 3 on the remaining Lower Legs,
Figure 2-4
5,
6,
7,
3
insert the 4 square hobs on the Long Honzontal
Support (9) over the ears on the Lower Leg (see
Figure 2°4), Using a rubber mallet or a hammer
with a wooden Mock, tap the HonzontaH Support
downward until the square hobs bottom out on
the ears on the iower iegs,
Repeat Step 5 on the Short HonzontaH Support (8)
See Figure 1ol,
Assemble the plastic Foot (10) onto the end of each
Leg, See Figure 1ol,