Machine Storage; Troubleshooting - Global 246687 Manual Del Usuario

MAINTENANCE
1. Clean the machine with a soft, damp cloth.
2. Remove the louver on the front panel to gain
filter access.
3. Remove filter mesh from unit.
4. Use a clean rag to absorb the surface dust on the filter
mesh. If the filter is extremely dirty, use tap water to flush
it out. Fully dry the filter before replacing it back into the
air inlet fence.
A clean filter will increase the unit's overall efficiency.

TROUBLESHOOTING

ISSUE
Machine is not operating.
Machine is operating, but
does not dehumidify.
Reduced dehumidifier
capacity.
No air inlet.
Loud operation.
Commercial Grade
Dehumidifier
CAUSE
Unit is not plugged in.
Room temperature is under 41
degrees or above 95 degrees F.
When the humidity set point is 2%
higher than the ambient humidity.
Filter mesh is jammed.
Air-in and/or Air-out louvers
are jammed.
Filter mesh or air-in louver
is jammed.
Machine is situated on an incline
or decline slope.
Filter mesh is jammed.
CAUTION:
Switch off the unit and unplug it immediately if anything abnormal
should occur. Contact a qualified electrician. Do not dispose of
electrical appliances as unsorted municipal waste; use separate
collection facilities. Contact your local government for information
regarding the collection systems available.

MACHINE STORAGE

If unused for an extended period of time, please store the
unit in the following manner:
1. Clean filter mesh.
ATTENTION:
The internal evaporator must be dry prior to storage to avoid
component damage and mold. Unplug the unit and place it in
a dry, open area. Another drying method is to set the humidity
point 2% higher than the ambient humidity to force the fan to
dry the evaporator.
2. Store the power cord in the back of the unit.
3. Store in a clean, dry environment.
Plug in unit.
For unit safety, use only when ambient temperature
is between 5 and 35 degrees.
Reset humidity levels to a lower set point, or power
off unit once optimal humidity levels have been met.
Clean filter mesh in accordance with
manual, specifications.
Clear blockage from Air-in and/or Air-out louvers.
Clean filter in accordance with instructions or remove
the louver blockage.
Move unit to an even surface.
Clean filter mesh in accordance with instructions.
4
User's Manual
SOLUTION