Publicidad
Idiomas disponibles
Idiomas disponibles
Select the polarity of DMX output.
18.
DMX OUT
Use to output DMX data.
19.
DC INPUT
DC 9V~12V, 300mA MIN.
PROGRAMMING FOR SCENES
Press PROGRAM for 3 second, appropriate LED blink, which indicates it is in PROGRAM mode.
1.
SECNE PROGRAMMING
I. Press SCANNER key to select DMX channel composed of 8 channels.
II. Select different channel to control several devices at the same time.
III. Adjust appropriate fades to select desired output level, than turn off fade.
IV. Select and adjust output level continuously until all devices are set.
V. Press MIDI/ADD.
VI. Select desired bank using UP or DOWN.
VII. Press SCENE to store this SCENE.
2.
SCENE EDITING
I.
Select desired scene of bank.
II.
Make program of scene to meet the requirement of device.
III. Press MIDI/ADD
IV. Press scene to store this scanner.
3.
SCANNER COPY
I.
If a scanner is set, press and hold the SCANNER first.
II.
Press the SCANNER to copy to , then the SCANNER is copied to anther SCANNER.
4.
SCENE COPY
I.
Select desired SCENE.
II.
Press MIDE/ADD once.
III. Select one bank, then press the scene to copy to.
5.
DELETE SCENE (DMX channel incorporated with this SCENE are set to 0)
I.
Select desired scene.
II.
While pressing and holding AUTO/DEL. Press scene required to be deleted.
6.
CLEAN ALL SCENE (ALL DMX channel are set 0.)
I. Press PROGRAM + DOWN while turning power off.
II. Turn the power on.
7.
COPY BANK
English
Pag. 6
TR-MQ 1000
TR-MQ 1000
Publicidad
