Publicidad
Idiomas disponibles
Idiomas disponibles
TOOL OPERATION
Fasteners
WCS200 standard crown stapler
The Paslode
®
drives Paslode
16 gauge fasteners designed to be
®
used with the tool. The use of fasteners that do not
meet Paslode standards could cause tool damage
and will void all warranty claims
Loading Fasteners
Step No. 1 – Disconnect the tool from the air
supply, pull back the rail follower until it latches at
the end of the magazine. The rail cover
will automatically open.
Step No. 2 – Insert the staple strip into the
magazine rail.
Step No. 3 – Press the follower latch release lever
or unlatch the follower and slide the follower
forward until it contacts the staple strip. Reconnect
air supply. The tool is now ready for use.
Depth of Drive Adjustment
Disconnect the air supply.
The depth of drive adjustment is done by turning
the adjustment wheel located below the trigger.
Clearing a Jam
An occasional problem you may encounter is a
jammed fastener. Because of the unique design of the
Paslode stapler, clearing a jammed fastener is easy:
1. Disconnect the air supply
2. Pull the latch, releasing front guide. Pivot front
guide forward.
3. Clear jam, and push driver blade back up to its
normal position.
4. Close front guide and latch it. Check that work
contacting element moves freely.
Lockout Feature
The purpose of this feature is to prevent needless
blank cycling, which could mar woods and damage
tool components. The work contact element will
lock when the follower reaches the lockout area.
When changing staple length or loading staples
at the beginning of the work day, you should inspect
the magazine and nose for any fasteners left in the
tool.
5
Publicidad
