KEF KASA500 Manual Del Usuario página 5

6
6. Voltage Select – Select your AC voltage
USB – For uploading new KASA500 DSP firmware
7.
KASA500 DSP firmware available for download at www.kef.com/kasa500
8. Software Rev. – For recording software revision with the supplied labels when updating KASA500 DSP firmware.
9. EQ-AMP – 8 Dip switches for selecting KASA500 DSP presets (Confirm software revision matches your preset selection).
10. EQ-LINE OUT – 4 Dip Switches for selecting Line Output DSP presets (Confirm software revision matches your preset
selection).
11. Line Output – RCA
Line level output to another KASA500 or power amplifier. When using single LFE input at "Line Input" (12) from receiver,
connect to CH1 and set "Stereo / Mono Input" (15) to Mono.
12. Line Input – Use for connecting to line level input signal
13. Speaker Inputs – Use for connecting to speaker level input signal
14. Line Out EQ / Pass through – Line Out with DSP preset / Direct Bypass
15. Stereo / Mono Input
Stereo maintains stereo signal into DSP.
Mono splits mono input into both DSP or amplifier channels.
16. 2 Channel / Bridge – Converts the 2 x 250watt into 4 Ohm amplifier into a monaural 500w x 1 into 8Ohm amplifier –
Unless otherwise instructed – Must be left in 2 Channel Position!
17. 12V DC IN – Input for "12V Trigger" (any polarity).
18. Manual/Music Sense/12V Trigger – Sets KASA500 Turn on control
Manual – KASA500 switches on with front panel On/Standby switch
Music Sense – if On/Standby switch is on, KASA500 switches on with music signal
12V Trigger – if On/Standby switch is on, KASA500 switches on with 12V trigger.
19. Speaker Outputs – Connect to subwoofer or speaker
Use Ch 1 / Ch 2 markings for 2 Channel mode, amp is optimised for 4 Ohm speakers.
Use Bridge marking when in bridge mode, amp is optimised for 8 Ohm speakers.
Continued on Page 26
KASA500 manual_11b_4301-7477+0.indd 5
All manuals and user guides at all-guides.com
7 9 11
8 10 14
12 13 17
15 16 18
19
5
2014/1/10 15:49:10