Publicidad
Idiomas disponibles
Idiomas disponibles
INSTALLATION
INSTRUCTIONS
If you have questions, visit our website at haierappliances.com
BEFORE YOU BEGIN
Read these instructions completely and carefully.
IMPORTANT –
•
for local inspector's use.
IMPORTANT –
•
codes and ordinances.
Note to Installer –
•
instructions with the Consumer.
Note to Consumer –
•
for future reference.
• Skill level – Installation of this appliance requires
basic mechanical and electrical skills.
• Completion time – 1-3 hours
• Proper installation is the responsibility of the
installer.
• Product failure due to improper installation is not
covered under the Warranty.
LOCATION OF YOUR WASHER
DO NOT Install the Washer:
1. In an area exposed to dripping water or outside weather
conditions. The ambient temperature should never be
below 60°F (15.6°C) for proper washer operation.
2. In an area where it will come in contact with curtains or
drapes.
3. On carpet. The floor MUST be a hard surface with a
make sure the washer does not vibrate or move, you may
have to reinforce the floor.
NOTE:
plywood sheet solidly attached to existing floor covering.
MOBILE HOME INSTALLATION:
Installation must conform to Standard for Mobile Homes, ANSI A119.1 and National Mobile Home Construction and Safety
Standards Act of 1974 (PL93-383).
16
or in Canada visit haiercanada.ca.
Save these instructions
Observe all governing
Be sure to leave these
Keep these instructions
TOOLS REQUIRED FOR
WASHER INSTALLATION
Level
Channel-lock adjustable pliers
PARTS SUPPLIED
Water Hoses (2)
(Flat washers
pre-installed)
IMPORTANT:
Minimum Installation Clearances
•
•
(2.54 cm)
• Consideration must be given to provide adequate
clearance for installation and service.
• Closet doors must be louvered or otherwise ventilated and
have at least 60 square inches (387.1 cm
the closet contains both a washer and a dryer, doors must
contain a minimum of 120 square inches (774.2 cm
open area.
WASHER
Wrench (provided)
Drain Hose Guide
) of open area. If
2
) of
2
49-3000191 Rev. 2
Publicidad
