Black and Decker LH4500 Manual De Instrucciones página 7

FOR LH5000 BAG:
• Empty the shoulder collection bag by sliding the retaining bar off the bottom of the bag as
shown in figure 14.
CAUTION: NEVER REMOVE THE COLLECTION BAG WITHOUT FIRST TURNING
OFF AND UNPLUGGING THE VACUUM.
NOTE: If the suction decreases and the bag is not full, the vacuum tube is probably clogged
with debris. Turn off and unplug the blower/vac and clear the tube before continuing.
• To reattach the retaining bar, close the bottom of the shoulder bag by folding the bi-folds flat
as shown in figure 15. Slide the retaining bar over the closed bag.
FOR LH4500 BAG:
As the bag fills the power of the suction will decrease, switch off your product and unplug from
power supply. Unzip the bag to empty before continuing to operate.
MAINTENANCE
• CLEANING AND STORAGE
TURN OFF AND UNPLUG TOOL! (Unplug extension cord at power source.)
Use only mild soap and a damp cloth to clean the tool. Never let any liquid get inside the tool;
never immerse any part of the tool into a liquid. Clean out any clippings which may have
accumulated in the Blower/Vac. When used properly with dry leaves the fan chamber of your
Blower/Vac should remain clean. If damp earth and debris are ingested some of the particles
may build up on the inside of the fan chamber. If this happens the performance of the unit will
decrease. This area can be cleaned out using a wooden stick as shown in figure 16 after
disconnecting from the power source. Your Blower/Vac should be stored in a dry place.
WARNING: SHOCK HAZARD. DO NOT POUR OR SPRAY WATER ON THE TOOL IN
AN ATTEMPT TO CLEAN.
Do not store the tool on or adjacent to fertilizers or chemicals. Such storage can cause rapid
corrosion of the metal parts.
14
15
16
7