Kreg Accu-Cut KMA2700 Manual Del Propietário página 8

Kreg Track Clamps
These clamps slide into notches in the starter block
and T-slots in the track to allow the track to be
clamped to the workpiece. They are recommended
when cutting material with a slippery surface, such
as melamine-coated particleboard, or when any of
these conditions exist: the entire length of the track is
not fully supported by the workpiece, the workpiece
is not flat, or when making cuts with a single section
of track.
Accu-Cut Expansion Pack
™
Double the cutting capacity of your Accu-Cut™ with
the Accu-Cut Expansion Pack. It connects easily to
your Accu-Cut to deliver the same straight, accurate,
splinter-free performance on cuts up to 100" long.
The Expansion Pack includes two additional 26.5"
Aluminum Guide Tracks, six steel Track Connectors,
eight Anti-Chip/Anti-Slip Guide Strips, and
instructions for assembly and setup.
Guide Strips
(Sold separately)
Over time, the guide strips can become worn and
no longer provide accurate alignment of the track
and zero-clearance chip prevention. This package
of two guide strips restores the accuracy and cut
quality of your Accu-Cut
the Accu-Cut XL.
™
Before using the Accu-Cut™, read, understand, and follow the safety warnings and operation instructions
WARNING
included with this product and provided by your saw manufacturer. Keep all tool guards and safety devices in place. Do not attempt
a cut when any part of the Accu-Cut™ interferes with the operation of the saw blade guard. Always wear eye and ear protection.
Use respiratory protection in dusty conditions. Disconnect the saw from power supply before making any adjustments to the
Accu-Cut™ or the saw.
OPTIONAL ACCESSORIES
(Sold separately)
(Sold separately)
REPLACEMENT PARTS
. You'll need four packs for
™