NAX 300C Manual página 41

RESIDUAL RISK
Despite the fact that the machine manufacturer bears responsibility for its construction eliminating danger, certain elements of risk
during operation are unavoidable. The residual risk arises from the erroneous behavior of the machine's operator. The greatest
danger occurs when performing the following prohibited activities:

use of the device by children,

use of the machine for other purposes than described in the Operation Manual,

when other people, especially children or animals are nearby,

use of the device by people not acquainted with the operation's manual,

using the device without proper, protecting operating clothing and footwear protecting foot,

using the device with damaged guards or the casing and without properly installed safety devices, e.g. shield guards etc.
When observing the instructions in the operating manual, the residual hazards of using the machine may be eliminated. There is a
risk in case of failure to comply with the above recommendations.
USAGE
The device is intended only for work in the home garden in accordance with the description and safety rules contained in these
operation manual. It can be used for cutting trees, cutting branches, preparing firewood and for other applications that require
pruning.
Other applications may be dangerous to users and may cause damage to the equipment.
The device should not be used to:

cutting materials other than wood and wood-based materials,

as a lever for lifting, moving or dividing objects.
ADDITIONAL INFORMATION FOR THE USER
Performing maintenance and adjustment work before or after the season can be a problem even for advanced users. The NAX
company would like to offer you a service consisting in preparing the machine for storage and / or work. The scope of this service
may include: candle replacement, cleaning, maintenance, oil change, filter replacement and lubrication of moving parts, knife
sharpening and balancing, as well as other work related to the adjustment and maintenance of equipment. This will ensure long-term
and reliable operation and safety of the device.
PREPARING FOR WORK
The saw is supplied by the manufacturer in a cardboard packaging in a partially disassembled state. After reading the operating
instructions and assembly drawings, assembling the chain saw should not be too difficult. All necessary components for assembly are
included in the packaging.
WARNING! The chain has very sharp edges. Use thick protective gloves for safety.

Stay away from the saw chain as it will start to rotate when the engine starts.

The handles should be dry, clean and free from oil or the fuel mixture.

Use extreme caution when cutting small branches and trees, as thin material can get stuck in the saw chain and hit the
operator or throw him off balance.

When cutting stressed boughs, be careful not to be hit when the stress in the wood fibers is reduced.

Check the tree for dry branches that may fall during felling operations.

Always stop the engine before putting the saw down.
CONSTRUCTION OF PETROL SAW
Illustrative drawings can be found on page 4, Fig. 1
EN 41