cecotec PERFECT&CLEAN CONNECTED ABSOLUTE Manual De Instrucciones página 47

Side brushes
Side brushes are designed with multiple bristles and are used to push dirt towards the suction
nozzle and to thoroughly clean edges and corners. These brushes can wear out over time,
affecting negatively to the cleaning efficiency. For this reason, it is suggested to replace each
side brush after a maximum of 220 hours or less.
Recommendation
It is recommended to clean the side brushes once a week with the help of the autoclean brush.
Sensors
Your robot vacuum cleaner has different types of sensors, for example, proximity sensors
-
that allow the robot to move around while detecting obstacles, or free-fall sensors that
help the robot detect slopes or possible gaps/unevenness such as staircases. These
sensors are always in contact with dust particles, and therefore can deteriorate over time,
causing possible navigation errors.
It is suggested to clean all the robot sensors with a dry and soft cloth after a maximum of
-
35 hours of operation or less.
Battery charge and replacement
To lengthen the battery shelf life, keep the robot charging on the charging base when not
-
in use.
Remove the battery and store it in a safe, dry place if the device will not be used for a long
-
period of time.
To replace the battery, follow the instructions below:
1. Unscrew the 2 screws on the battery slot, remove the battery cover and the battery.
Fig. 30
2. Insert the new battery with the battery label facing up. Fig. 31
3. Place the battery and the battery cover in its place and fix properly the screws back
again.
6. TROUBLESHOOTING
Beeps while the oscillating red light is on:
Beeps Error
01 1 Gyroscope error
Solution
Place the robot vacuum cleaner on a stable surface
and restart it by turning it off and on with the power
switch. Do not move it.
ENGLISH
47