Descargar Imprimir esta página

cecotec IMMORTAL EXTREMESUCTION 22,2 HAND Manual De Instrucciones página 19

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 16
ENGLISH
Warning
When vacuuming liquids, do not exceed the MAX mark on the dust tank.
Charge light indicator
-
Do not connect the charger while you use the product.
-
Connect the charger to the power socket. Make sure the vacuum cleaner is off before
connecting the charger. Fig. 2
-
The blue light indicator will flash when the device is connected to the charger.
-
The blue light indicator will remain steady when it is operating.
-
To ensure the product is always ready to be used, we recommend you charge it while not
in use.
-
The charger may heat up during charge. This is normal.
-
When the battery level is low, the light indicator will flash again.
Warnings
-
We do not recommend using the vacuum cleaner while it is charging.
-
The battery provided is the only battery compatible with the vacuum cleaner. Do not use
the charger to charge non-rechargeable batteries.
-
Unplug the vacuum cleaner if it is not going to be used for long periods of time.
Emptying the dust tank
Fig .3
-
Remove the dust tank by pressing the release button.
-
Remove the filter and the plastic protection and empty the dust tank content. Shake the
filter or clean it with warm water, without detergent. Make sure the parts are completely
dry before reassembling them.
-
Wash and rinse the tank if necessary.
-
Place the tank back in its position. It will click into place once properly positioned.
Note:
Make sure all parts are dry before placing them back in their position.
-
Place the filter in the dust tank. Place the dust tank in the main unit following the removal
procedure in reverse order.
4. CLEANING AND MAINTENANCE
-
Use a soft, dampened cloth to clean the product's exterior housing.
-
Wash the dust tank with water and dry it carefully before placing it back in the vacuum
cleaner.
36
CONGA IMMORTAL EXTREMESUCTION 22,2 HAND/ANIMAL HAND
-
Check the filter's condition regularly. If it is dirty, clean it with a small brush and rinse it
with water. Let it air dry for 24 hours and reinstall it when it is completely dry.
5. TECHNICAL SPECIFICATIONS
Model: Conga Immortal Extreme Suction 22,2 V Animal Hand/Conga Immortal Extreme Suction
Hand 0,5L 22,2 V Black
Product reference: 05441/05440
Power socket: 220-240 V, 50 Hz
Technical specifications may change without prior notification to improve product quality.
Made in China | Designed in Spain
6. DISPOSAL OF OLD ELECTRICAL APPLIANCES
This symbol indicates that, according to the applicable regulations, the
product and/or battery must be disposed of separately from household
waste. When this product reaches the end of its shelf life, you should
dispose of the batteries/accumulators and take them to a collection point
designated by the local authorities.
Consumers must contact their local authorities or retailer for information
concerning the correct disposal of old appliances and/or their batteries.
Compliance with the above guidelines will help protecting the environment.
7. TECHNICAL SUPPORT AND WARRANTY
Cecotec shall be liable to the end user or consumer for any lack of conformity that exists at the
time of delivery of the product under the terms, conditions, and deadlines established by the
applicable regulations.
It is recommended that repairs be carried out by qualified personnel.
If at any moment you detect any problem with your product or have any doubt, do not hesitate
to contact Cecotec official Technical Support Service at +34 963 210 728.
8. COPYRIGHT
The intellectual property rights over the texts in this manual belong to CECOTEC INNOVACIONES,
S.L. All rights reserved. The contents of this publication may not, in whole or in part, be
reproduced, stored in a retrieval system, transmitted, or distributed by any means (electronic,
mechanical, photocopying, recording or similar) without the prior authorization of CECOTEC
INNOVACIONES, S.L.
CONGA IMMORTAL EXTREMESUCTION 22,2 HAND/ANIMAL HAND
ENGLISH
37

Publicidad

loading