Aritech PR2000C Instrucciones De Instalación página 2

4
EN: Installation Sheet
Description
The PR2000C is a 40-column thermal printer designed for use
with Aritech 2000C series fire alarm control panels.
Installation
To install the printer:
1. On the control panel door cut through the plastic layer that
covers the slot using a sharp knife, and mount the printer
to the inside of the door using the screws provided.
Ensure that the paper roll is aligned with the slot (see
Figure 1).
2. Install the printer power supply onto the mounting plate in
the control panel cabinet (see Figure 2).
To connect the printer:
WARNING: Disconnect the mains power supply and the
batteries before making any connections.
1. Connect the red, orange, and black power cables to the
printer and to +V OUTPUT and −V OUTPUT on the printer
power supply (Figure 3, item 4). See Table 1 below.
2. Connect the red and black power cables from J17 (PRINT)
on the PS1200N to +V INPUT and −V INPUT on the
printer power supply (Figure 3, item 2). See Table 1
below.
3. Connect the earth cable from the printer power supply to
the earth stud in the control panel cabinet (Figure 3, item
3).
4. Connect the serial cable from the printer to PORT2 or
PORT3 on the FC2012 CPU host module (Figure 3, item
1).
Printer power supply connections are shown below.
2 / 24
5
Table 1: Printer power supply connections
Terminal (Printer Cable colour
power supply)
+ INPUT 1 red
− INPUT 1 black
1 green/yellow
+V OUTPUT 1 red / 1 orange
−V OUTPUT 2 black
Use cable ties to secure all cables.
To configure the printer:
1. Go to the port setup menu on your control panel (System
> Configuration > Communication > Port Setup) and
configure the control panel to printer communication as
shown in Table 2 below.
2. Reset the control panel.
Table 2: Port setup at the control panel
Menu Option
Port SER1 (for PORT2 on the FC2012)
SER2 (for PORT3 on the FC2012)
Allocation
Event printer Ev. Pri.
Report printer Rp. Pri.
Printer Thermo
Baudrate 9600
Protocol 8, 1, n
To load the paper:
1. Open the cover at the front of the printer and insert the
paper as shown in Figure 4.
2. Pull the leading edge of the paper up to align with the exit
slot and close the cover as shown in Figure 5.
To test the printer:
1. Print a list of events from the events menu on your control
panel (Events > Display Events > Destination > Ev. Pri. >
Execute).
P/N 10-3312-501-1P01-03 • ISS 07JUN22
Connect to
PS12000N
PS12000N
Control panel earth stud
Printer power connector
Printer power connector