① x 2
E
A/C/D
② x 4
7. Lay one Backrest (A) on a smooth and protective surface with the threaded inserts facing up.
8. Insert the tenon of both Side Stretchers (E) into the mortises of the Backrest (A). Make sure that the
slant holes on the Side Stretchers will face the floor when the unit is turned upright.
9. Attach the assembled Seat Frame (B) to the middle rail of the Backrest (A) and insert both Side
Stretchers (E) into the Front Legs (C and D) respectively. Insert four 80 mm Bolts (2) with Lock
Washers (4) and Flat Washers (5) through the drilled holes on the Seat Frame (B) at rear corner blocks
and loosely tighten into the threaded inserts on the Backrest (A). As shown.
10. Secure the Seat Frame (B) to the Backrest (A) by inserting two 38 mm Bolts (1) with the Large Washers
(4 and 5) through the drilled holes on the rear rail of the Seat Frame. Tighten the bolts with the Ratchet
Wrench provided.
NOTE: DO NOT
fully
Assembly Instructions
B
C
E
tighten the bolts in steps 9 and 10.
D
E
A
④ x 6
5
B
2
4
5
1
4
5
A
⑤ x 6