Publicidad
Idiomas disponibles
Idiomas disponibles
F
Slant holes face upward
C
③ x 4
ready to assemble. To avoid causing damages to the thread, DO NOT over-tighten the nuts or bolts.
1. Unpack the unit and confirm that you have all the hardware and required parts listed. Assemble the unit
on a carpeted floor or the empty carton to avoid any scratch.
2. Position one Seat (B) upside down on a level and protective surface.
3. Remove the plastic caps from the hanger bolts of the Front Legs (C and D) for the following steps.
4. Attach one Left Front Leg (C) to the left front corner of the Seat Frame (B) by inserting the hanger bolts
through the drilled holes on the corner block and fit the Flat Washer (5), Lock Washer (4) and Hex Nut
(3) onto each hanger bolt. Tighten the nuts with the provided open wrench.
NOTE: DO NOT fully tighten all the nuts until the stool has been adjust and level all the legs so that
they do not wobble. Once adjusted then go back and tighten while making sure that the unit remains level.
5. Insert the tenon of one Front Stretcher (F) into the mortise of the Left Front Leg (C). Make sure that the
slant holes on the stretcher will face the floor when the unit is turned upright.
6. Repeat the same procedure to attach one Right Front Leg (D) to the right front corner block of the Seat
Frame (B). Be sure the mortise on Right Front Leg (D) fits onto the tenon of the Front Stretcher (F) properly.
Assembly Instructions
C/D
F
B
④ x 4
DO NOT fully tighten the bolts or nuts initially until all the bolts or nuts are
C/D
D
5
4
3
4
Pre-attached
C/D
B
⑤ x 4
Publicidad
