Publicidad
Idiomas disponibles
Idiomas disponibles
ENGLISH
Recommendation
It is recommended to clean the side brushes once a week with the help of the autoclean brush.
Sensors
-
Your robot vacuum cleaner has different types of sensors, for example, proximity sensors
that allow the robot to move around while detecting obstacles, or free-fall sensors that
help the robot detect slopes or possible gaps/unevenness such as staircases. These
sensors are always in contact with dust particles, and therefore can deteriorate over time,
causing possible navigation errors.
-
It is suggested to clean all the robot sensors with a dry and soft cloth after a maximum of
35 hours of operation or less.
Battery charge and replacement
-
To lengthen the battery shelf life, keep the robot charging on the charging base when not
in use.
-
Remove the battery and store it in a safe, dry place if the device will not be used for a long
period of time.
To replace the battery, follow the instructions below:
1.
Unscrew the 2 screws on the battery slot, remove the battery cover and the battery. Fig.
29
2.
Insert the new battery with the battery label facing up. Fig. 30
3.
Place the battery and the battery cover in its place and fix properly the screws back again.
6. TROUBLESHOOTING
Beeps while the oscillating red light is on:
Beeps
Error
Solution
01
1
Gyroscope error
Place the robot vacuum cleaner on a stable surface and
restart it by turning it off and on with the power switch. Do
not move it.
02
2
Bumper error
Check the bumper and remove any object that may be
blocking it.
03
3
Free-fall sensor
Check if the bumper is dirty and clean the sensor.
error
02
4
Low battery or
The robot has run out of battery and you need to manually
charging error
place it on the charging base.
46
Beeps while the indicator light is steady red:
Beeps
Error
Solution
01
1
Driving wheel error
Check if the driving wheel is blocked. Unblock and clean
it.
02
2
Robot side brushes
Check if the side brushes are blocked and clean them.
error
03
3
Fan error
Clean the dust or objects that may be blocking the air
inlet channel.
02
4
Main brush error
Check if the main brush is tangled or blocked and clean
it.
Other possible scenarios:
Problem
Solution
The robot vacuum cleaner
Make sure the power switch is in the on position (I).
does not activate.
Make sure the battery is fully charged.
If the problem continues, turn the switch off and restart it.
The device suddenly stops
Check if the robot is trapped or stuck with any obstacle.
working.
Check the battery level.
If the problem continues, turn the switch off, wait for 2 seconds and
restart it.
The programming function
Make sure the power switch is in the on position (I).
does not work
Check if the robot battery is too low to turn on.
Suction power level is very
Check if there are obstructions blocking the air inlet.
low
Empty the tank.
Clean the filters with a vacuum cleaner or a cleaning brush.
Check if the filters are wet.
Dry the filters in a natural way before using them. Make sure they
are completely dry, if there are any moisture remains they could
reach the motor and damage the robot.
The robot vacuum cleaner
Check if the charging base indicators are on. If they are not, contact
does not charge.
the official Technical Support Service of Cecotec.
Clean the charging terminals with a dry cloth.
Check if the robot beeps when it gets to the charging base.
Otherwise, contact the official Technical Support Service of Cecotec.
ENGLISH
47
Publicidad
