Classe CA-2100 Manual De Instrucciones página 12

Idiomas disponibles

Caution!

Also, it is a good practice to physically disconnect any and all valuable

electronics from the AC mains during electrical storms, as a lightning

strike anywhere near your home can put a tremendous surge on the AC

mains that can easily damage any piece of electronics, no matter how well

designed and protected. The best protection in the case of severe electrical

storms is to simply remove the electronics from any connection with the

power grid.

Select button

The Select button is used (along with the Mode button) when conﬁguring

the ampliﬁer for either balanced or single-ended operation. It is also used

when conﬁguring the turn-on delay or ampliﬁer number for an ampliﬁer

connected to a Classé preampliﬁer by the DC Trigger or CAN Bus control

systems.

Channel status LED indicators

Each ampliﬁer channel has two Channel LED indicators. They are used to

indicate the use of either balanced (XLR) or single-ended (RCA) inputs for

that channel.

These indicators are also used to indicate fault conditions in your ampliﬁer,

should any ever arise. If a channel's LED indicators blink red, there is a

problem in that particular channel. If all the Channel LEDs are blinking

red, there may be a systemic problem that is not speciﬁc to a particular

channel.

If you see any Channel LED Indicator blinking red, please

disconnect the ampliﬁer from the AC mains immediately and

check that all external connections are cleanly made and

secure. If the AC mains are not easily accessible, you can press

and hold the Standby button for three seconds to reset the

ampliﬁer. If no fault is immediately obvious, please call your

authorized Classé dealer for assistance.

Mode button

The Mode button is used (along with the Select button) when conﬁguring

the ampliﬁer for either balanced or single-ended operation. It is also

used when conﬁguring the turn-on delay and ampliﬁer number of the

ampliﬁer when it is connected to a Classé preampliﬁer by the CAN Bus

communications or Trigger systems.