HAEGER Ultra Warm GH-42B.005A Instrucciones De Uso página 12

Instructions for use
Control Buttons
Lighting Position
A – Piezoelectric button
1 – The front grill
3 – Pilot flame
The heater can be regulated to three different heat settings: LOW (1 ), MEDIUM (2 ) and
HIGH (3 ). The ignition is operated by piezo electric push button.
1. Open the valve on the gas cylinder one turn and half.
2. Turn the control knob to START position, press down and hold it for 10 seconds.
3. Whilst still pressing down the control knob, press several times on the ignition button
until the pilot flame ignited at the bottom of the burner. Continue to hold the control
knob down for another 15-20 seconds. When releasing the button and if the pilot
flame goes out, repeat the operation.
4. When first igniting a new heater, it may be necessary to hold the control knob down
for a longer time in order to allow gas to flow to the pilot burner.
5. When the heater is burning at the LOW (1 ) stage, please wait for around 4 minutes.
The heating element will start glowing and will become red. After that you can turn
the control knob to the MEDIUM (2 ) position, again wait around 4 minutes in this
position. Finally, you can turn the control knob to the HIGH (3
NEVER PUT THE APPLIANCE DIRECTLY ON THE HIGH (3
THIS THE HEATER MIGHT NOT BE ABLE TO DIGEST THE GAS IN A PROPER WAY AND
THERE MIGHT BE EXCESSIVE FLAMING COMBUSTION.
6. In order to shut off the heater, you need to turn back the control knob to the start
position and close the cylinder valve fully (in clockwise). The heater can only be shut
off by closing the gas cylinder valve fully. It cannot be turned off by the control knob.
Safety devices (FFD, ODS, Anti-Tilting)
The heater incorporates several safety devices that will shut down the heater in unsafe
conditions.
1. In case of accidental flame failure, the heater will shut down automatically.
Minimum Position
B – Control button
2 – Ceramic burner
4 – Castors
10
Medium Position
) POSITION. AS A RESULT OF
Maximum Position
) position.