Parts And Components; Before Use; Product Assembly; Operation - cecotec CONGA ROCKSTAR STATION Manual De Instrucciones

ENGLISH

1. PARTS AND COMPONENTS

Fig. 1
1. Base
2. Accessory holder
3. Upper anchor and charger holder
4. Joint piece
5. Lower pillar
6. Upper pillar

2. BEFORE USE

- Take the product out of the box.
- Check carefully if there is any damage. If any is observed, contact as soon as possible the
Technical Support Service of Cecotec for advice or reparation.

3. PRODUCT ASSEMBLY

Base assembly
- Place the base on solid ground, ensure the entire surface of the base is in contact with the
ground.
- Install and fix the lower pillar on the base using two screws.
- Install and fix the joint piece on top of the lower pillar using two screws.
- Install and fix the upper pillar on top of the joint piece using two screws.
- Install and fix the accessory holder on top of the upper pillar using two screws.
- Install and fix the accessory holder on top of the upper pillar using two screws. Fig. 2

4. OPERATION

Vacuum cleaner placing and charging
- Place the vacuum cleaner in a vertical position on the base, to prevent falls make sure the
vacuum cleaner fits perfectly on the slot of the upper anchor and charger holder. Fig. 3
- To charge the battery plug the charger into the charging point placed in the back of the
upper anchor and charger holder. Fig. 4
34