cecotec READYWARM 21000 CARBON FOCUS Manual De Instrucciones página 34

ENGLISH
1. PARTS AND COMPONENTS
Fig 2.
1. Heater head
2. Upper tube
3. Central tube X 2
4. Bottom tube
5. Cable and plug
6. Base
7. Base anchoring
8. Trim
2. BEFORE USE
Installation
General
Keep the packaging material out of the reach of children. Check that all parts are present.
-
Before use, make sure that you have removed all wrappings around the head (lamp,
socket, and switches). Ensure that the area of use is kept clear and away from flammable
materials.
Check that the appliance, power cord and plug are not damaged. If you notice any damage,
-
do not connect the device to the mains!
Do not connect the outdoor heater to the power supply before it has been fully assembled.
-
To assemble the outdoor heater, you will need to use some specific tools. Follow the
-
instructions below step-by-step. If in doubt, please contact your distributor.
3. ASSEMBLY
It is recommended that the outdoor heater is mounted between two people.
Fig 3.
Pass the cable through the bottom, through the base and the bottom tube (the plug must
remain at the bottom).
Fig 4.
Screw the lower tube securely to the base using the three M6x25 screws.
-
Place the trim piece on the tube.
-
Pass the cable through the central tube (x3) and screw the latter tightly to the lower tube.
-
Then pass the cable through the upper tube and screw it tightly to the central tube.
-
Carefully pull the cable upwards.
-
34
READYWARM 21000 CARBON FOCUS