Rupes LHR 12E Traduccion Del Manual De Instrucciones Originale página 6

TECHNICAL SPECIFICATIONS
TYPE
PICTOGRAPH
WARNING. For your personal safety, READ and UNDER-
STAND the instruction manual before using
Important safety indications
Use personal
protective equipment.
Double insulated tool.
INSULATION CLASS II
CE compliant
WARNING! Read all safety warnings, instructions,
illustrations and speci cations provided with this
power tool. Failure to follow all instructions listed below may
warnings and instructions for future reference.
The safety and accident prevention instructions are reported
in the "SAFETY INSTRUCTION" booklet which is an integral
part of these documents. This operating instructions manual
use of the tool.
CORRECT USAGE
This tool is designed to e used as a polisher.
This tool is not intended to e used for smoothing, metal
rushing and cutting operations. The use of this tool for
people.
The tool must e used with accessories that have een
speci cally designed or recommended y the manufacturer.
safe operation.
The rated speed of the accessories must
equivalent to the ma imum speed speci ed on the tool.
Using the accessories at speeds above the rated one, may
The e ternal diameter and thickness of the accessories
must match the speci cations of the tool. Accessories
with incorrect dimensions cannot be adequately protected or
controlled.
The con guration of accessories must match the tool.
tool may result in imbalance, excessive vibrations and in the
impossibility of controlling the tool.
Do not use damaged accessories. Before use, inspect all
the accessories. Inspect the supporting pads and verify
there are no cracks, tears or e cessive wear. If the tool or
accessory has fallen, verify that it is not damaged or install
a new accessory. After inspecting or installing an accessory,
test the operation of the tool at ma imum speed and without
load for one minute, keeping at a safety distance. If the
accessories are damaged, they will break during this test.
SPECIFIC SAFETY WARNINGS
Verify that no loosened part of the polishing tool shroud or
the locking ties can rotate freely. Safely position or cut all
the loosened
may twist around the operator's ngers or get caught y the
work piece eing machined.
STARTING UP
TOOL ASSEMBLY
Save all
ACCESSORIES ASSEMBLY
BACKING PAD
POLISHING FOAM
START AND STOPPING
POLISHING FOAM
e at least
START AND STOPPING
LHR 12E
ing wires. Loosened or revolving
ENGLISH
6
LHR 75E
ing wires