ORDO SONIC LITE SL01-ST Información Importante página 5

vibration than if you were using a manual or battery-powered toothbrush. Some
people notice a slight tickling or buzzing sensation – this will pass in time. We
recommend using the Sensitive mode for the first 1-2 weeks, then trying the Clean
mode once you've become accustomed to the sensation.
Your Sonic Lite toothbrush has two modes: Sensitive and Clean. The Sensitive mode
is good for people with sensitive teeth or gums, while the Clean mode is perfect for
powerful everyday cleaning. Each mode can be selected by pressing the power
button multiple times until you reach your desired mode.
Your Sonic Lite remembers the last mode you used, so next time you use it, all you
need to do is press the power button and you're good to go.
It's common for first-time users to apply too much pressure. The benefit of an electric
toothbrush is that it does the brushing for you, so you only need to apply gentle
pressure. Please follow the instructions below for the best brushing experience.
This toothbrush is safe to use on braces, dental restorations (fillings, crowns, bridges,
implants), and cosmetic dental work (veneers, composite bonding), as long the dental
work is properly adhered and not compromised. Please ask your dentist for advice if
you're unsure in any way.
Brushing instructions:
1. Wet the bristles and apply a pea-sized amount of toothpaste.
2. Place the toothbrush bristles at a 45-degree angle to the teeth, pressing just
enough to make the bristles reach the gum line.
3. Press the power/mode button to switch on the toothbrush and select your desired
mode.
4. Remember not to press too hard when brushing, let the vibrating bristles do the
work of clearing away plaque and food debris – no need to scrub as you might
with a manual toothbrush.
5. Guide the bristles across and between your teeth, using small back and forth
motions.
6. To ensure you thoroughly brush all surfaces of your teeth, split your mouth into
four quadrants: top teeth outer surfaces, top teeth inner surfaces, bottom teeth
outer surfaces, bottom teeth inner surfaces. Use the inbuilt Quad-Pacer to guide
you between each of the quadrants – every 30 seconds the vibrations will pause
briefly to let you know it's time to move onto the next quadrant.
7. After 2 minutes the toothbrush will automatically switch off, letting you know that
you've brushed your teeth for the dentist recommended time. Of course, you can
switch the toothbrush back on if you'd like to brush for longer.
8. If at any time before the end of a 2-minute cycle you want to turn the toothbrush
off, simply press the power/mode button.
9. Once you're done with brushing, spit out any excess toothpaste, but do not rinse
your mouth with water. This allows the ingredients of the toothpaste to better
protect your teeth.
10. Thoroughly rinse the bristles, brush head and handle, ensuring you wash away
any toothpaste residue.
Charging Your Sonic Lite Toothbrush
1. When the rechargeable battery is low, the battery indicator will flash red.
2. Pop open the charging cover on the bottom of the toothbrush. To help open the
charging cover, it has a small cut-out near the "ORDO" logo on the back of the
toothbrush.
3. Ensure the entire toothbrush is fully dry, paying particular attention to the bristles
and the area around the charging cover and USB-C charging input.
4. Using the included USB cable, connect the USB-A connector to a power source,
then connect the USB-C connector to the USB-C charging input on the toothbrush.
5. The battery indicator will light up red to show the toothbrush is being charged.
6. Allow the toothbrush to charge for 4 hours or until the charging light shows green.
7. Disconnect the USB cable from the toothbrush and switch off the power source.
8. Securely and fully close the charging cover, ensuring the entire cover is pushed
closed as far as it will go.
5