TMC Therm 50 Manual De Instrucciones página 6

INSTRUCTIONS FOR INSTALLATION AND USE
Important Safety Information - Please Read Carefully
• Always isolate the heater from the mains electricity before
installing or carrying out any maintenance.
• Power to the heater must be supplied through a Residual
Current Device (RCD) with a rated residual operating current
not exceeding 30mA.
• The heater is designed to run completely submerged in water
- do not operate out of water.
• If removing the heater from the aquarium or sump, isolate it
from the power supply and wait approximately 15-20 minutes
for it to cool, BEFORE removing it.
• Heater rating: 220-240V, 50Hz unless marked otherwise.
• Do not operate any appliance if it has a damaged cord or plug,
if it is malfunctioning, or if it has been dropped or damaged in
any way.
• This heater is designed to be used indoors and is not suitable
for any outdoor applications.
• Ensure the heater is securely installed before operating.
• Always leave a drip-loop in the heater cable to prevent water
running down the cable and reaching the power source (see
picture).
• This appliance is not intended for use by persons (including
children) with reduced physical, sensory or mental capabil-
ities, or lack of experience and knowledge, unless they have
been given supervision or instruction concerning use of the
appliance by a person responsible for their safety.
Check with your local authority for disposal information.
Dispose of this unit responsibly.
6 6