Burley Dash FM Manual Del Usuario página 12

Attaching the Frame Mounting System
to Your Bicycle
Remove the Mounting Plate
the Mounting Block
provided Hex Wrench to remove the
4 screws and lock washers
8NM
Re-attach the Mounting Plate to the Mounting
Block using the 4 screws with lock washers.
Position any cables so that they run though
the central channel between the frame
protector and the mounting plate
Tighten the 4 screws in a crisscross pattern
and in stages to a torque value of 8NM. Check
the security of the fasteners regularly. Ensure
that the space between the Mounting Plate
and Mounting Block is even on all sides.
12
ASSEMBLY & USE
A
B
C
1
from
A
by using the
B
.
C
A
3
A
ENG
Open the Frame Protector on the Mounting
Block wide, and wrap it around the Seat Tube
of your bicycle, with the Mounting Block facing
toward the front of the bicycle, and orient
with the Mounting Rail holes facing upwards.
The Frame Protector should go underneath any
cables so that there is nothing between the frame
protector and the bicycle frame.
.
FRA ESP
2
note
BURLEY.COM