Publicidad
Idiomas disponibles
Idiomas disponibles
Operating Your Refrigerator
IMPORTANT:
Do not plug in the unit for at least 24 hours after unit is set in place.
Failure to do so may result in the unit working improperly.
This
refrigerator/beverage
cooler
has
a
rotary
temperature
control
knob
(thermostat)
marked with the settings
COLD, 2, 3, 4, 5, 6, COLDEST
in order of
increasing
coldness.
In addition,
this model employs
a heater inside the cabinet,
and is designed
for outdoor
use.
When the temperature
is colder than the tem-
perature setting, the heater works automatically
to maintain the temperature
setting.
Note:
To prevent
excessive
strain on the compressor,
do not leave the
unit at the COLDEST
setting for more than an hour at a time.
OPERATING
INSTRUCTIONS
Turning
on the Unit
The refrigerator
turns on automatically
when it is plugged in.
Note:
If you unplug the refrigerator
or the power is cut off accidentally,
allow 8 minutes before restarting
it or plugging
it back in. It will not
operate
properly
in less than 8 minutes.
Temperature
Setting
Initially set the thermostat
to setting 4. The compressor
will run continuously
for a
few hours and only after the temperature
inside the appliance
becomes stable will
the compressor
run normally
(i.e., turn on and off periodically).
When the unit is operated
for the first time, it is suggested
that you not put foods in
until the compressor
is running normally.
Adjusting
the thermostat
counter-clockwise
will make the compressor
run for a
longer time with a shorter
compressor
stop time, and the temperature
inside the
appliance
will be colder. The setting
should
be regulated
according
to ambient
conditions
and the desired temperature.
The compressor
will run for a while after
each regulation
before reaching
a steady temperature.
Please note: Cold air falls and warmer air rises, and there will be a small
temperature
variation
from
the
bottom
of
the
unit
to the top.
The
temperature
at the bottom of the unit will always be slightly colder.
Publicidad
