Publicidad
Idiomas disponibles
Idiomas disponibles
The maximum drop distance must never exceed 20 cm.
A safety rope which already hold the strain of a crash or which is defective must not be used again.
Adjust the desired inclination-angle via the mounting-bracket and tighten the fixation screws.
Before taking into operation for the first time, the installation has to be approved by an expert!
Master/Slave-operation
The master/slave-operation enables that several devices can be synchronized and controlled by one master-
device.
On the rear panel of the LCC-18/LCC-36 you can find an XLR-jack (DMX Out) and an XLR-plug (DMX In),
which can be used for connecting several devices.
Choose the device which is to control the effects. This device then works as master-device and controls all
other slave-devices, which are to be connected to the master-device via a balanced microphone lead.
Connect the DMX OUT-jack with the DMX IN-plug of the next device.
Set DIP-switch No. 11 to On for the master-device. Set DIP-switch No. 1 to On for all slave-devices.
Occupation of the DIP-switches:
DMX-512 connection / connection between fixtures
120 Ohms
Projector 3
Starting address 15
The wires must not come into contact with each other, otherwise
DANGER TO LIFE!
1 2 3 4 5 6 7 8 9 10 11 12
DMX Address
1 2 3 4 5 6 7 8 9 10 11 12
Music Control
1 2 3 4 5 6 7 8 9 10 11 12
Master/Alone
the fixtures will not work at all, or will not work properly.
Projector 2
Starting address 8
20/47
DMX512
DMX-512 Controller
Projector 1
Starting address 1
51841315_V_1_2.DOC
Publicidad
