Publicidad
Idiomas disponibles
Idiomas disponibles
_
L
_
_
_.
_. •
1. The object under test should be larger than the spot (target) size calculated
by the field
of view diagram.
2.
If the surface of the object under test is covered with frost, oil, grime, etc., clean before
taking measurements.
3.
If an object's surface is highly reflective, apply masking tape or flat black paint to the
surface before measuring.
4. The meter may not make accurate measurements
through transparent surfaces such
as glass.
5.
Steam, dust, smoke, etc. can obscure measurements.
6. The meter compensates
for deviations
in ambient temperature.
It can, however, take
up to 30 minutes for the meter to adjust to extremely wide ambient temperature
changes.
7. To find a hot spot, aim the meter outside the area of interest then scan across (in an up
and down motion) until the hot spot is located.
,v_ r_,! I #II/ =1 # r_,l # [,1"
1.
KEEP THE METER DRY. If it gets wet, wipe it off.
2. USE AND STORE THE METER IN NORMAL TEMPERATURES,
Temperature
extremes can shorten the life of the electronic parts and distort or melt plastic parts.
3.
HANDLE THE METER GENTLY AND CAREFULLY,
Dropping it can damage the
electronic parts or the case.
4.
KEEP THE METER CLEAN, Wipe the case occasionally
with a damp cloth. DO NOT
use chemicals, cleaning solvents, or detergents.
5. USE ONLY FRESH BATTERIES OF THE RECOMMENDED
SIZE AND TYPE.
Remove old or weak batteries so they do not leak and damage the unit.
6. IF THE METER IS TO BE STORED FOR A LONG PERIOD OF TIME, the batteries
should be removed to prevent damage to the unit.
REPLACING
THE BATTERIES
n
When the low battery symbol r] appears on the lower left side of the
display, replace the meter's battery (9V). The battery compartment
is
located
behind the black panel that surrounds
the meter's trigger
(see diagram).
Open the compartment
by pulling the black panel
down from the trigger area. Replace the 9V battery and close the
battery compartment
cover.
Publicidad
