Avision MiWand 2 Lite Guia De Inicio Rapido página 2

Start a Scan
1. Place your document on a flat surface.
2. Press
3. Hold the scanner and glide the scanner gently over the surface of the page as illustrated.
4. During scanning, the scan speed (SP0~SP1) will be displayed on the screen. "SP0" indicates the
5.
Refer to the following list for a proper scan speed (based on an A4-size paper):
0.6 second (B&W, STD) / 1.6 second (Color, STD)；2.4 second (B&W, HQ) / 6.5(Color, HQ)
View or download the scanned images (PC)
1. To view or download your scanned images, you can either remove the
micro SD card and connect it to a card reader, or connect the scanner to
your computer via the supplied USB cable (be sure to turn on your
scanner).
2. Your computer should recognize the card or the scanner as a Removable
Disk.
3. Click the Removable Disk and you will find a folder of [DCIM] is created
and all the PDF files will be stored in the subfolder of [200DOC] and the
JPEG files in the subfolder of [100PHOTO]. File name starts from
IMG_0001.pdf or IMG_0001.jpg.
View or download the scanned images (iPad)
1. Plug the iPad Camera Connector （ not included） to iPad dock connector. Plug the USB connector
to iPad Camera Connector.
2. The scanned images in the micro SD
seconds. Choose [Import All] to load the scanned images to the album of your iPad.
Troubleshooting:
displayed. Refer to the following table to clear the error conditions.
Error
E02/No SD card
E03 / Card Full
E08 / Low battery
E05 / No image scanned
E06 / Calibration Fails
SP1 / Scanned speed too
fast
None
Note:
For more detailed information on how to operate the scanner, please download the user's manual from our official web site

on http://www.avision.com.
 Please register your product on our web site to have complete technical support.
You may download the free image editing software application – the Avision Image Editing Helper to enhance your image

quality after completing product registration on our web site.
to start a scan.
lowest speed while "SP1" is warning you the scan speed is too fast. To obtain the best image quality,
please keep your speed at the lowest level (SP0).
Press to stop the scan. If successful, scan count (001) will be displayed.
incremented sequentially.)
TM
card of your scanner will be displayed in iPad in 3
If there is error during scanning, the LED light will be flashing in red color and error codes will be
Problems/Causes
1. No memory card inserted.
2. Card not recognized.
Card full; Images can not be saved.
Battery power is getting low
1. No scan data detected.
2. Scanner time out.
Scanner has detected a calibration error
Images look distorted (Scanning speed too
fast)
Vertical lines appeared on images (The glass
and rollers are dirty.)
How to restore
1. Insert a memory card.
2. Try a new different card.
Free more space or insert a new memory card.
Replace batteries (or recharge if using rechargeable
batteries).
Wait until the code disappears.
Recalibrate the scanner (See User Manual for details.)
Rescan original again with a lower speed.
Clean the glass and rollers with the supplied cleaning
cloth.
2
(Next scan for 002,
http://www.avision.com