cecotec READYWARM 2000 MAX CERAMIC ROTATE SMART Manual De Instrucciones página 37

Box content
Heater
-
Instruction manual
-
Remote control
-
3. OPERATION
1. Once plugged in, switch on the appliance by pressing the switch, position "I". To switch it
off, put it in the "0" position.
2. Press the power icon once to start the fan in low mode. Press the icon again to switch the
fan off.
Standby: If no icon is pressed during 10 minutes of operation, the display will turn off. Press
-
any icon to turn the display back on.
3. Press the heating mode selection icon to toggle between Low and High mode.
4. Press the oscillation mode activation icon to make the fan rotate from side to side during
operation. Press the icon again to stop oscillation.
5. Press the timer icon to keep the fan on for the selected time. "0" indicates that the timer
will not be activated.
6. Press the temperature setting icon to set a target temperature within the range 15 - 45ºC.
If the set temperature is equal to or lower than the room temperature, the appliance will
-
stop heating.
If the set temperature is 1-2°C higher than the room temperature, the appliance will
-
operate in Low mode.
If the set temperature is +3°C higher than the room temperature, the appliance will operate
-
in High mode.
7. Press ECO and a default temperature of 22ºC will be set.
When the difference between the room temperature and the set temperature is more than
-
4ºC, the appliance will operate in High mode.
When the difference between the room temperature and the set temperature is more than
-
4ºC, the appliance will operate in Low mode.
When the room temperature is higher than the set temperature, the appliance will stop
-
heating.
4. CLEANING AND MAINTENANCE
1. Before cleaning the heater, make sure that it is unplugged.
2. Use a damp cloth with a little neutral detergent to clean the device. Do not use other
solvents.
3. The heater must be used or stored after it has completely cooled down and dried out.
READYWARM 2000 MAX CERAMIC ROTATE SMART
ENGLISH
37