T243 Operation
NOTE: T243 supports wireless connections only (no integrated AUX input)
a. Remove dust cover & turn speaker switch ON (Blue LED light will flash quickly to indicate
speaker is ready for pairing).
b. Activate Bluetooth on your audio device and select Bluetooth signal Spector T243 (blue LED light
will remain lit when devices are successfully paired)
c. To DISCONNECT from wireless mode, press & hold the
d. To power off, remove dust cover and switch OFF
NOTE: previously paired devices will automatically re-connect to the T243 speaker when both devices
are turned on & within range.
2. Operation in Wireless Mode
Press to play/pause in music mode (Blue LED will flash slowly when music is paused)
1)
Press quickly to skip to next song/Press & hold to increase the volume
2)
Press quickly to skip to previous songs/ Press & hold to decrease the volume
3)
Press to answer/end incoming call
4)
To Charge T243
a. Insert the Micro-USB charging cable into the speaker & connect USB output to a wall adapter (not
included).
b. Red LED light indicates the speaker is in charging mode (LED light will turn off when speaker is
fully charged)
FCC STATEMENT
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received,
including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant
to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause harmful interference
to radio communications.
Microphone
LED Indicator
Volume Up
Play/Pause/Answer/End call Button
Volume Down
ON/OFF Switch
Dust Cover
button for 3 seconds
Charging input