HomeMatic IP HmIP-ESI-IEC Manual De Instalacion Y Uso página 20

Start-up
6.2.2 Screw mounting
When selecting the installation
location, check for electrical wires
and power supply cables.
A round headed screw with a 3
mm diameter is to be used for
mounting.
To mount the HmIP-ESI using a screw,
proceed as follows:
• Draw a drill hole on the chosen
position using a pen.
• Screw the screw into the wall (use
a wall plug if necessary).
For wooden walls, you can pre-
drill the hole with a 1.5 mm drill to
make it easier to screw in the
screw.
The clearance between the bot-
tom of the screw head and the
mounting surface should be ap-
proximately 2 mm.
• Thread the screw channel (C) on
the rear side over the screw head.
2
Put the cover (B) onto the electronics
unit (D), ensuring that it latches fully
into place.
1
6.2.3 Mounting the sensor
To mount the sensor, proceed as fol-
lows:
• Place the reader head (G) in the
centre of the meter interface.
The integrated magnet ensures it re-
mains in place. With standard-com-
pliant interfaces, the cable is routed
downwards.
• Finally, insert the sensor connector
(H) on the underside of the HmIP-
ESI into the connection point (E)
until it audibly clicks into place.
20