Publicidad
Idiomas disponibles
Idiomas disponibles
MOUNTING AND WIRING INSTRUCTIONS
CAUTION: For fixtures labeled for outdoor and wet location use, provide a water-tight seal
between the fixture and the mounting surface by using silicone or similar caulking.
NOTE: Underwriters Laboratories (UL) does not require all fixtures to have ground wires. These
fixtures meet all UL specifications.
1. Turn off power at circuit box to avoid possible electric shock.
2. Thread mounting screws (A) into universal mounting plate or cross bar (B) approximately
1/4 inch (see fig. 1).
NOTE: If universal mounting plate or cross bar (B) was preinstalled, remove cap nuts (C) and
universal mounting plate or cross bar (B) from back plate (D), leaving mounting screws (A) in place.
3. Secure universal mounting plate or cross bar (B) to outlet box (E) with outlet box screws (F).
4. Identify color coding of fixture wires (see fig. 2).
5. To connect wires, take black fixture wire (group A from fig. 2) and place evenly against
black outlet box wire. Do not twist wires.
6. Fit wire connector (G from fig. 1) over wires and twist until there is a firm connection. If
wire connector (G) easily comes off, reattach and check again for a firm connection.
7. Repeat steps 5 and 6 with the white (group B from fig. 2) fixture wires and outlet box wires.
8. Partially thread green grounding screw (H) into side hole (I) on universal mounting plate or
cross bar (B) (see fig. 1).
9. Wrap ground wire from fixture around green grounding screw (H), leaving enough excess
wire to then connect ground wire and outlet box wire with wire connector (G) (see step 11).
10. Tighten green grounding screw (H). Do not over tighten.
11. Tuck wires inside outlet box (E) (see fig. 1).
FIXTURE ASSEMBLY INSTRUCTIONS
1. Position back plate (D) over mounting screws (A) and secure with cap nuts (C).
2. Remove two set screws (J) from fixture cover (K) and separate from fixture body (L), then
remove and discard paper and foam padding (if applicable).
3. Install lamp(s). Do not exceed recommended wattage.
4. Lift fixture body (L) into fixture cover (K) and secure with set screws (J).
5. Turn power back on at circuit box.
4
Publicidad
