Matikgate ULTRA Serie Manual Usuario/Instalador página 76

CONNECTIONS STATUS
EN
When the control unit is in standby, it can read the input status from the display.
No active input
Active opening input
Active closing input
Active start input
Active pedestrian entrance
Active photocell input
Attention:
During automatic close, the display shows the countdown from the seconds to closing.
POTENTIOMETERS
TR1 = S.D. SPEED - Speed regulation in deceleration.
TR2 = OBST.D. - Sensitivity regulation / Obstacle detection.
TR3 = REGULATION - Regulation of the slowdown time.
PROGRAMMING WORKING TIME AND TRANSMITTERS:
Au
QUICK PROGRAMMING WORKING TIMES
To quickly program the working times, press and hold UP (3 seconds) until
If the door is not fully closed, it will close to the limit switch, then open at the open limit switch, and finally close once.
If you are not sure which direction the door is facing, place it in the fully closed position before starting programming, the board will
assume the limit switch as the close side and automatically manage the motor direction (see menu
c1
QUICK PROGRAMMING OF TRANSMITTERS
Press shortly DOWN to record a transmitter,
Then press the button of the transmitter you want to program.
Lc
See menu for more functions.
Ar
AUTOMATIC PROGRAMMING OF TRANSMITTERS
It is possible to record transmitters quickly without using the basic menu.
To insert a new transmitter with the gate closed, transmit 3 times with the new transmitter, pausing at least 1 second between each transmission.
Then transmit 3 times with the transmitter already in memory and once with the new one. Once programming is complete, the board's stop led
flashes once.
This function must be enabled, see the advanced menu
M M
MASS ENTERING MODE (exclusive function for use in barriers)
In this mode, press the OPEN command 5 times (example), the control panel counts 5 passes through the detection sensor (DET input, guaranteed
closing function), then closes the door.
This mode must be enabled in the advanced menu
76
MATIKGATE AUTOMATION
Au
c1
appears in the display.
Ar
.
MM
. It can be enabled only when automatic closing is disabled.
Active detection input
System is unlocked
Active non-closing opening input
Active opening limit switch input
Active closing limit switch input
Active stop input
TS1
TR1
S.D. SPEED OBST.D.
appears on the display.
Gd
TS2 TS3
TR2
REGULATION
in the advanced menu).